|
|
|
|
Thread Tools | Display Modes |
07-09-2019, 07:21 AM | #1 |
Scooby Specialist
Member#: 74041
Join Date: Nov 2004
Chapter/Region:
Tri-State
Location: Suburbia PA
Vehicle:2006 2012 Weee-strom 14 Hyundai Borenata |
Need machine shop good with Subaru - Allentown area
Hi all. I am in the middle of rebuilding a motor and I am at the bearing clearance measurement part and I am not confident in my measurements. I am looking for a machine shop that could measure the crank, block mains, rods, pistons, and bore for me. I have the engine apart, cleaned up, bearings in the rods and block and everything torqued down. Just need measurements done. I am in the Allentown area but traveling an hour or so is fine. Please let me know, thank you.
* Registered users of the site do not see these ads.
|
07-09-2019, 08:19 AM | #2 |
Trust no one
Moderator Member#: 11170
Join Date: Oct 2001
Chapter/Region:
Tri-State
Location: NYC
Vehicle:02 RAV4 MT 15 WRX/11 CRZ |
There may be a few people here in that area, but I'd suggest posting in Mid-A as well.
|
07-09-2019, 10:19 PM | #3 |
Scooby Newbie
Member#: 503883
Join Date: Jul 2019
Chapter/Region:
Tri-State
Location: Collegeville, PA
Vehicle:2019 WRX STi World Rally Blue |
I have had a lot of Subaru cylinder heads taken care of when I get cars in for head gaskets by my local machine shop - Stauffers located in phoenixville, probably about an hour or so from Allentown. Worth giving them a call and seeing if they would take care of your block, they are certainly knowledgeable and trustworthy. And if you have them take care of it I am about 15 minutes from their shop, stop by and say hello!
|
Thread Tools | |
Display Modes | |
|
|