|
|
|
|
Thread Tools | Display Modes |
03-10-2005, 06:59 PM | #1 |
Scooby Specialist
Member#: 20391
Join Date: Jun 2002
Chapter/Region:
NESIC
Location: Reading, MA
Vehicle:'01 Range Rover HSE NESIC TrackHoh #555 |
ECUTek'd JDM ECU into a USDM WRX question, pre-engine swap
Was told to post here from the Engine Management forum:
Building a hybrid EJ2.2T / JDM V7 head / V8 valvetrain to swap into my '02 WRX. I want to run AVCS when I do the swap, but in the mean time I want to ECUTek tune the car as it's set up right now (TXS UTEC Stg4). The Question: Can I run an ECUTek'd JDM ECU in my USDM car, then reflash it when I swap the engine out? If yes, what side-effects can I expect, if any? -Jason
* Registered users of the site do not see these ads.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
JDM STI (V6) into 2005 USDM WRX questions | fl4tsc | Subaru Conversions | 24 | 01-09-2009 08:35 PM |
JDM WRX Ver. 5 Trans into 05 USDM WRX? | th3t00n4 | Transmission (AT/MT) & Driveline | 3 | 11-04-2008 05:29 PM |
installing jdm 2.5 ecu into 95 usdm 1.8 harness.. couple of ?'s | 2slofouru | Normally Aspirated Powertrain | 16 | 10-15-2007 09:44 AM |
ECUTek'd JDM ECU into a USDM WRX question, pre-engine swap | jpmarotta | Engine Management & Tuning | 1 | 03-10-2005 08:21 AM |
JDM 97 legacy EJ20TT into 03 USDM WRX | marksWRX03 | Subaru Conversions | 9 | 09-01-2004 05:34 PM |