|
|
|
|
Thread Tools | Display Modes |
01-25-2006, 05:22 PM | #1 |
Scooby Specialist
Member#: 4986
Join Date: Mar 2001
Chapter/Region:
NESIC
Location: Back frm Ireland Fallbrook, Ca
Vehicle:2002 BlzYel JDMSTiv7 GRP 08 FXT |
JDM EJ207- Where to install oil pressure sensor
So when I had my USDM WRX EJ205 motor I had installed my apexi oil pressure sensor into the port on the block below the intake manifold/alternator. I had removed the set screw type thing on the block and installed some NPT fittings and a little metal line to raise the locoation of my sensor to above the intake manifold. The sensor has what, an 1/8" NPT fitting.
This worked well. This seems like (being the engineer that I am) a better place than adding on a oil filter adapter to install sensors. The oil filter adapter just seems kinda hokey, but would work perfectly fine. So on my JDM EJ207 swap where is the best place to install the oil pressure sensor? Is there a similiar port or bung on this EJ207 block or do I just go the route of the filter adapter?
* Registered users of the site do not see these ads.
|
01-25-2006, 05:48 PM | #2 |
Scooby Guru
Member#: 832
Join Date: Jan 2000
Chapter/Region:
RMIC
Location: Teh Ghetto Garage, CO
Vehicle:99 2.5RS, '85 911 '73 914 and 2012 BRZ |
Unless there is something unique about the EJ207, every Ej series block I have ever seen has that port you used...
|
01-25-2006, 07:23 PM | #3 |
Scooby Specialist
Member#: 43916
Join Date: Sep 2003
Chapter/Region:
RMIC
Location: Old Town
Vehicle:2001 Impreza 4.7 Blue Ridge Pearl |
you saw the one on the V7 block matt, its there.
now, if anyone has that part number for the subaru part that goes into that bung..... anyone? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
installed oil pressure sensor-> CEL | Lamb155716 | Factory 2.5L Turbo Powertrain (EJ Series Factory 2.5L Turbo) | 3 | 04-29-2008 11:28 PM |
Where to install oil pressure sensor? | Alaskan EJ20 | Alaskan Impreza Club Forum -- AKIC | 10 | 02-21-2008 08:56 PM |
Where to put oil pressure sending unit? | rok_toy | Factory 2.5L Turbo Powertrain (EJ Series Factory 2.5L Turbo) | 4 | 09-09-2005 10:29 AM |
Where to get oil pressure sensor | SLowery | Electrical & Lighting | 9 | 04-12-2003 11:44 PM |
Help - where to get oil pressure fittings | CStearns | Bay Area Impreza Club Forum -- BAIC | 2 | 03-30-2002 11:01 PM |