|
|
|
|
Thread Tools | Display Modes |
04-16-2010, 05:04 PM | #1 |
Scooby Specialist
Member#: 174442
Join Date: Mar 2008
Chapter/Region:
Tri-State
Location: NNJ
Vehicle:2007 SuperWagon I don't spell well |
ACL vs OEM bearings - sizes and clearences ?
I searched and didn't find anything so:
Why do ACL bearings have 2 sizes (normal, +1) and oem bearings have 5 different sizes? If I were to use OEM bearings, I could mix and match bearings until I'm within spec for clearance, but it doesn't look like I can do that with the ACL due to the limited sizes available. Do the ACL have different specs? How do I get the ACLs within spec?
* Registered users of the site do not see these ads.
|
04-16-2010, 06:38 PM | #2 |
Scooby Specialist
Member#: 56345
Join Date: Mar 2004
Location: CO
Vehicle:1997 OBS Primer Grey |
ACLs come in -.025mm, STD and +.025mm.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FS: STi internals and ACL main/rod bearings | scubienick | Engine/Power/Exhaust | 21 | 06-16-2010 05:29 PM |
Question about factory block bearing sizes stamp and after market bearings size 1 2 3 | STIStalker | Built Motor Discussion | 1 | 03-14-2010 04:53 PM |
NEW EJ25 Phase 1 Crankshaft and ACL Rod/Main bearings | MadDogSTi | 1993 - 2001 Impreza Specific Parts | 0 | 03-09-2009 01:09 PM |
street motor, OEM bearings or ACLs? | Davenow | Built Motor Discussion | 19 | 04-04-2008 11:09 AM |
VOTE: On OEM rotor size and pads | CRAZY KEN | Brakes, Steering & Suspension | 2 | 07-02-2001 12:39 AM |