|
Brakes & Suspension Forum sponsored by The Tire Rack |
|
|
|
Thread Tools | Display Modes |
05-13-2009, 07:29 AM | #1 |
Scooby Newbie
Member#: 19651
Join Date: Jun 2002
Location: PA
Vehicle:2002 WRX Silver |
question re: steering column to rack attachment after bushing install
I installed steering rack bushings yesterday. To make it easier I loosened the clip on the splines to lower the rack, not enough to remove, just let the rack lower a bit.
When reassembling I 'think' I pushed things up a bit higher than where it was originally (lower linkage connection on splines of column). Any chance of this creating a problem? Hopefully the terms don't confuse - not sure what they are called?
* Registered users of the site do not see these ads.
|
05-13-2009, 07:55 AM | #2 |
Former Vendor
Member#: 93646
Join Date: Aug 2005
Chapter/Region:
MWSOC
Vehicle:Many Track Records Let us help you go fast! |
As long as the bolt goes through the joint it should be fine.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Steering is crazy after bushing install - HELP! | scoobydrew06 | Brakes, Steering & Suspension | 13 | 05-03-2010 09:19 PM |
Does an 05 steering column and rack bolt in? | dankster | Subaru Conversions | 4 | 07-20-2009 11:07 AM |
If steering column to steering linkage bolt fell out, would steering fail? | garface | Brakes, Steering & Suspension | 7 | 03-18-2009 01:56 PM |
connecting steering column to steering rack?? | skivancleave | Rocky Mountains Impreza Club Forum -- RMIC | 2 | 05-26-2008 07:07 PM |
WTB 06 forester steering column to steering rack swivel joint | 2slofouru | Private 'Wanted' Classifieds | 1 | 08-02-2007 07:02 PM |