I can't figure out how to remove my viscous coupling

mk2jettavr6 · 01-14-2008, 10:43 AM

took off rear cover of transfer case and removed both shafts and all thats left to come out is the coupling but it inly can be wiggled a tiny bit but i cant seem to pull it out.

any trick to do this?

* Registered users of the site do not see these ads.

mk2jettavr6 · 01-14-2008, 07:14 PM

btw this is an 02 wrx 5mt

to me it feels like the bearing may be what is holdong it in

ttt

Tim Sanderson · 01-14-2008, 11:26 PM

Sounds like it's a little cocked. Try putting the drive transfer shaft in it and wiggle it. Be careful, it's a heavy chunk af steel.

rodknock02 · 01-15-2008, 09:58 AM

LOL go to the kitchen and eat a box of wheaties then try again.Tim Sanderson is right it pretty heavy.

01-14-2008, 10:43 AM	#1
mk2jettavr6 Scooby Newbie Member#: 168962 Join Date: Jan 2008 Chapter/Region: NESIC Vehicle: 02 wrx black	I can't figure out how to remove my viscous coupling took off rear cover of transfer case and removed both shafts and all thats left to come out is the coupling but it inly can be wiggled a tiny bit but i cant seem to pull it out. any trick to do this? * Registered users of the site do not see these ads.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Can't figure out how to backup yur Xbox360? Post on a MS blog!	-=C=-	Off-Topic	0	06-04-2008 05:42 PM
Can't figure out how to install clutch clips	noitseuq	Transmission (AT/MT) & Driveline	1	02-25-2007 01:50 PM
Can't figure out how to calibrate tps ??	L80Killa87	UTEC	2	01-02-2007 08:12 AM
I Can't Figure Out How To....(n00b ? inside)	binky	Off-Topic	19	08-07-2004 06:01 PM
Help: Can't figure out how to install headlight bulb and harness back into headlight	Gypsum2	Interior & Exterior Modification	2	07-29-2002 12:25 PM

01-14-2008, 07:14 PM	#2
mk2jettavr6 Scooby Newbie Member#: 168962 Join Date: Jan 2008 Chapter/Region: NESIC Vehicle: 02 wrx black	btw this is an 02 wrx 5mt to me it feels like the bearing may be what is holdong it in ttt

01-14-2008, 11:26 PM	#3
Tim Sanderson Scooby Guru Member#: 6486 Join Date: May 2001 Chapter/Region: MWSOC Location: S.E. wisconsin Vehicle: 00 Impreza 2.5 RS Blue Ridge Pearl	Sounds like it's a little cocked. Try putting the drive transfer shaft in it and wiggle it. Be careful, it's a heavy chunk af steel.

01-15-2008, 09:58 AM	#4
rodknock02 Scooby Newbie Member#: 150484 Join Date: Jun 2007 Chapter/Region: Tri-State Location: BANGOR PA Vehicle: 2000 RShybrid35rPPG SRP	LOL go to the kitchen and eat a box of wheaties then try again.Tim Sanderson is right it pretty heavy.