|
|
|
|
Thread Tools | Display Modes |
03-05-2001, 07:44 PM | #1 |
Scooby Newbie
Member#: 3173
Join Date: Dec 2000
Location: Waltham
Vehicle:01 RS CPE STM |
How hard is it to install frt bumper?
I'm talking about the cover, not the inner beam. Does it take a lot of skill? Is there a site containing direction? I did a search, but it was not very helpful. Thanks in advance.
* Registered users of the site do not see these ads.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How hard is it to install an EBC and power meter? | PrinceWRX | Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo) | 2 | 10-23-2001 09:32 AM |
How hard is it to install new forged pistons? | Delicious Tuning | Normally Aspirated with bolt-on Forced Induction Powertrain | 13 | 10-16-2001 06:23 PM |
how hard is it to install/remove a mid pipe? | Keith | Normally Aspirated Powertrain | 5 | 01-21-2001 12:50 AM |
how hard is it to install your own brake pads? | Keith | Technical Forum Archive | 20 | 10-06-2000 02:16 PM |
How hard is it to install springs? | Turbotegra | Technical Forum Archive | 15 | 07-08-2000 12:00 AM |