|
|
|
|
Thread Tools | Display Modes |
11-17-2018, 07:58 AM | #51 |
Scooby Newbie
Member#: 376219
Join Date: Dec 2013
|
Unfortunately those results are typical for a line hone.
* Registered users of the site do not see these ads.
|
11-17-2018, 10:17 AM | #52 |
Scooby Newbie
Member#: 440533
Join Date: Feb 2016
|
My mistake, wrong thread.
Last edited by stealthlead; 11-17-2018 at 01:43 PM. Reason: posted in wrong thread |
11-17-2018, 11:08 AM | #53 |
Scooby Guru
Member#: 15822
Join Date: Feb 2002
Location: TOPOHTO
Vehicle:1999 WRB GM6 2.34 LR destroker |
install bearings, check clearance and post results
|
07-04-2020, 10:21 PM | #54 |
Scooby Newbie
Member#: 142017
Join Date: Feb 2007
|
How long do the mains stay straight ?
I have measured 3 blocks all of which have had little hard use and I was surprised to find all three out of size. Is it the way FUJI machines them ? Do they machine them in halves to begin with hence why they have so many different size bearing shells available for assembly. |
Thread Tools | |
Display Modes | |
|
|