|
|
|
|
Thread Tools | Display Modes |
03-28-2004, 05:05 PM | #1 |
Scooby Specialist
Member#: 9548
Join Date: Aug 2001
Chapter/Region:
RMIC
Location: Colorado Springs
Vehicle:2004 WRX STi 10.154 @139 @ 7,000'DA |
help
i went to start my sti for the first time this morning, and i did not let it crank quite long enough to start before letting the key return to run. well i tried again and it would not start even with extended cranking. so i cycled the key off for a couple of seconds, then tried again. once i started cranking the CEL started blinking, and i can hear a relay clicking over by the ecu. the car will not start!
i have checked all fuses, and tried to read any cel codes with my code puller. the code puller can't read the ecu, it gives me an error message. anyone had this problem. i have done much searching with no answers. Thanks for any help! cnstman car is 100% stock
* Registered users of the site do not see these ads.
|
03-28-2004, 11:06 PM | #2 |
Scooby Guru
Member#: 1847
Join Date: Jul 2000
Chapter/Region:
Tri-State
Location: brokenmotorsports.com
Vehicle:Team Broken: V6 GF rallyarmor.com |
sounds like you flooded it.
Hold the gas pedel to the floor and crank it over for about 10 seconds, do this 2 or 3 times each time not cranking it for more than 10 seconds, and wait like 10 seconds between cranks. If it is flooded this should clear out any fuel in the combustion chamber. Then try and start the car without touching the gas. If that doesnt work, time to tow it to the dealer, thats what the warranty is for. Jay |
03-28-2004, 11:18 PM | #3 |
Scooby Specialist
Member#: 9548
Join Date: Aug 2001
Chapter/Region:
RMIC
Location: Colorado Springs
Vehicle:2004 WRX STi 10.154 @139 @ 7,000'DA |
got it running, something with the ecu was locked up. i pulled the ingintion fuse but that did not do anything, had to unhook the - terminal on the batt and reset. after that it runs like new
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
No Crank no start mmkay? | Trogasarus | Electrical & Lighting | 3 | 11-19-2009 11:45 PM |
crank no start question?? | xblackdeathx | Factory 2.5L Turbo Powertrain (EJ Series Factory 2.5L Turbo) | 4 | 06-12-2008 11:22 PM |
Crank/no start - no spark - ideas? | PeteDucati | Built Motor Discussion | 12 | 04-29-2007 04:29 PM |
Crank.. no start.. severe flooding??? | PeteDucati | Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo) | 7 | 02-10-2006 11:43 PM |
XT6 (92), Does anyone have a illustration of the timing belt(s) Crank No Start. | munkis | Normally Aspirated Powertrain | 0 | 10-20-2002 11:25 PM |