|
|
|
|
Thread Tools | Display Modes |
12-19-2007, 05:40 PM | #1 |
Scooby Newbie
Member#: 122603
Join Date: Aug 2006
|
limit of the std ECU
I am just about to commence a built 2.5 litre probably mated with an FP red and wanted to know at what point will the MAF based system become a limiting factor in it.
I am contemplating other ecu's but would rather stay with std ecu because of the excellent knock control strategy in place. The maf scaling at present should allow resolution up to 460 gram/sec although the top end of this scale has not been tested for obvious reasons. Power / Torque targets are over 500/500 at the flywheel running 99 octane and 10% in tank methanol mix other bits: APS CAI 70mm APS DR725 FMIC 840cc injectors 3inch full decat |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Anyway around the 24.75 psi target boost limit in the 16bit ECU? | Phatron | Open Source Reflashes | 10 | 11-06-2008 06:24 PM |
The limits of the RS or any subaru | HOK | Normally Aspirated with bolt-on Forced Induction Powertrain | 73 | 01-23-2007 03:03 PM |
Question: what is the age limit of the US draft? | edkwon | Off-Topic | 50 | 08-22-2005 08:45 PM |
Has anyone found the limits of the stock fuel pump yet? | Corn-Picker | Factory 2.5L Turbo Powertrain (EJ Series Factory 2.5L Turbo) | 16 | 04-01-2004 10:37 PM |
wha's the limit of the stock fuel system? turbo? & intercooler? | vile | Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo) | 4 | 05-02-2003 05:06 PM |