|
|
|
|
Thread Tools | Display Modes |
10-20-2020, 03:53 PM | #26 | |
Scooby Specialist
Member#: 30804
Join Date: Dec 2002
Chapter/Region:
SWIC
Vehicle:87 Yugo Red |
Quote:
* Registered users of the site do not see these ads.
|
|
10-20-2020, 04:51 PM | #27 |
Scooby Specialist
Member#: 395275
Join Date: Jul 2014
Chapter/Region:
RMIC
Location: Fort Lupton, CO
Vehicle:2012 STi SWP |
I have ~400 miles on my Emerald Coast closed deck block.
I sent them case halves and pistons but did the assembly myself JE Ultra 99.75 pistons Manley H-tuff rods King bearings 2020 STi crank Car is super quiet and has almost no piston slap. PTW clearance was set at .035 according to JE I have no complaints, but wish the communication was better from the shop. I had to ask them multiple times what they set the PTW clearance to as they didn't tell me when they shipped the block back. The woman I spoke to on the phone was courteous but tried arguing with me that I didn't pay for them to fit the pistons to the block despite me declaring in my original email that I wanted the pistons fitted to the bores, and the extra cost associated with it. She had to go back to their machinist who finally told her he set it to .035 I had the rotating assembly balanced locally, and asked that machine shop to check the PTW clearance just in case. they said it was dead on at .035 and that the block looked really good in their opinion. YMMV |
10-31-2020, 09:59 AM | #28 |
Scooby Specialist
Member#: 344120
Join Date: Jan 2013
Chapter/Region:
Tri-State
Location: Nj
Vehicle:15 sti limited wrb |
Using there cd casehalves had them pin my mains and drill out studs to 14mm and do .25 over im using je ultras 200 miles on break in so far so good no weird noises leaks ectt
|
11-17-2020, 08:43 PM | #29 |
Scooby Newbie
Member#: 415361
Join Date: Mar 2015
Location: syracuse ny
Vehicle:02 impreza wrx red |
I had them do mine solid work everything checked out. Would recommend them anytime!
|
11-22-2020, 09:15 PM | #30 |
Scooby Newbie
Member#: 520000
Join Date: Nov 2020
|
Been looking around for someone to do the closed deck service. I may just try here
|
Thread Tools | |
Display Modes | |
|
|