RH Intake AVCS cam gear

casey_jones · 05-21-2022, 11:44 AM

The RH intake AVCS dowel pin hole has what looks like two positions that the dowel pin can go in, do I put it in the left side of the dowel pin hole or the right dowel pin hole? I can seat the dowel pin but it moves back and forth, not sure which position to torque it.

http://i.imgur.com/gpUXLDW.jpg

Sent from my iPhone using NASIOC

* Registered users of the site do not see these ads.

2.5LBoxer2 · 05-21-2022, 06:02 PM

Photo doesnt work.

casey_jones · 05-22-2022, 10:21 AM

Quote:

Originally Posted by 2.5LBoxer2

Photo doesnt work.

It works on mobile. Nasioc image upload doesn’t work either. It’s definitely shot though. Looks like it got out on with the dowel pin only halfway into the hole and it peened over.

Sent from my iPhone using NASIOC

benflynn · 05-22-2022, 11:35 AM

I can’t see it but I think they smush the hole bigger if you tighten them down wrong.

casey_jones · 05-23-2022, 06:36 AM

Quote:

Originally Posted by benflynn

I can’t see it but I think they smush the hole bigger if you tighten them down wrong.

I’m pretty sure that’s what happened

Sent from my iPhone using NASIOC

big_krish · 05-26-2022, 11:41 PM

Can confirm, on my intake gears only one position fits correctly. If it was ever torqued down on the incorrect one, the hole in the cam is likely damaged.

05-21-2022, 11:44 AM	#1
casey_jones Scooby Newbie Member#: 511807 Join Date: Feb 2020	RH Intake AVCS cam gear The RH intake AVCS dowel pin hole has what looks like two positions that the dowel pin can go in, do I put it in the left side of the dowel pin hole or the right dowel pin hole? I can seat the dowel pin but it moves back and forth, not sure which position to torque it. http://i.imgur.com/gpUXLDW.jpg Sent from my iPhone using NASIOC * Registered users of the site do not see these ads. Last edited by casey_jones; 05-21-2022 at 04:01 PM.

05-21-2022, 06:02 PM	#2
2.5LBoxer2 Scooby Newbie Member#: 529466 Join Date: Mar 2022	Photo Photo doesnt work.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-22-2022, 11:35 AM	#4
benflynn Scooby Specialist Member#: 515308 Join Date: Jun 2020	I can’t see it but I think they smush the hole bigger if you tighten them down wrong.

05-26-2022, 11:41 PM	#6
big_krish Scooby Newbie Member#: 530206 Join Date: May 2022	Can confirm, on my intake gears only one position fits correctly. If it was ever torqued down on the incorrect one, the hole in the cam is likely damaged.