From top to bottom:
1. Top nut
2. Strut top
3. Conical washer (big side downward)
4. Upper perch
5. Upper spring seat (rubber thing)
6. Spring (insulator installed)
7. Strut (bump stop and dust boot on strut)
Am I missing anything?
I need to run to the store to get a deep 19mm socket for the top nut.
Also, I'm using spring compressors. Is the following assembly correct?
1. Compress spring
2. Put compressed spring in place on lower spring perch on strut
3. Put upper spring seat/perch/conical washer/tophat.
4. Put on top nut to start the threading
5. UNCOMPRESS spring so top nut is holding spring in place
6. Torque top nut down (on uncompressed spring) to spec (40 ft/lbs).
Thanks!