|
|
|
|
Thread Tools | Display Modes |
04-19-2003, 11:22 PM | #1 |
Scooby Newbie
Member#: 21597
Join Date: Jul 2002
|
WRX intake manifold/TB question
I was wondering if anyone knew the functionality of the air passage located above the normal circle TB hold on the intake manifold? also if i were to place a blockage over this passage would it cause any engine problems? thanks BK
* Registered users of the site do not see these ads.
|
04-20-2003, 10:58 AM | #2 |
Scooby Guru
Member#: 7089
Join Date: May 2001
Chapter/Region:
NWIC
Location: Western Wa
Vehicle:2016 STi |
Your question is poorly worded...
If you're talking about the small hole inside the throttle body, on the top before the throttle plate, then that's the Idle Air Control solenoid air passage. The ECU controls what RPM you're idling at by how much air is sucked through that hole at an idle/when your throttle plate is shut. Don't plug it up. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
08 WRX intake manifold/intercooler question. | ITP | Newbies & FAQs | 3 | 01-24-2009 12:05 AM |
FS -Chicago- 02' WRX Intake Manifold, TB, TGV's, VF30 + more..... | KenSekiguchi | Engine/Power/Exhaust | 23 | 08-13-2008 08:02 PM |
NJ WTS/WTT APS 'Type R' FMIC, Stock wrx TGV's, intake manifold, TB ready for porting | elsanto | Engine/Power/Exhaust | 10 | 09-17-2007 04:32 AM |
stock intake manifold TB to manifold flange, stainless uppipe to turbo flange | White 2.5rs | Engine/Power/Exhaust | 6 | 04-02-2007 01:24 PM |
'02-04 WRX intake manifold/tb/sensors | annointed | Private 'Wanted' Classifieds | 6 | 03-05-2005 02:30 PM |