|
|
|
|
Thread Tools | Display Modes |
04-05-2004, 11:33 PM | #1 |
Scooby Specialist
Member#: 31506
Join Date: Jan 2003
Location: Pasadena, CA
Vehicle:05 Tacoma on TE37' White |
Question about Autometer EGT Gauge...
Hey guys. I'm wondering if my gauge is messed up. It's a autometer Ultra-lite 52mm EGT gauge, and the needle sits at 2. It hasn't been hooked up, but just taken out of the box. Is it ok/right to be sitting at 2 or should it be sitting at 0??
Basically....is my gauge defective or is it ok?
* Registered users of the site do not see these ads.
|
04-06-2004, 01:20 PM | #2 |
Scooby Newbie
Member#: 27962
Join Date: Oct 2002
Chapter/Region:
MWSOC
Location: Indy/East side
Vehicle:2003 WRX Sedan Blue, with more dings! |
It's OK
Mine did the same thing. Autometer Z series. The temperature in the dash is changing the resistance in the gauge giving you a reading. Now you'll know if your dash overheats! Once you finish the install be prepared to see alot more than 200 degrees.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
autometer egt gauges, what egt probe are you using? | Tobey | Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo) | 15 | 07-09-2004 11:19 PM |
Autometer EGT Gauge Question | Terbeauwrx | Engine Management & Tuning | 24 | 02-20-2004 04:43 PM |
Autometer EGT Gauge question | jetsiphon | Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo) | 15 | 11-14-2003 05:00 PM |
Questions about Autometer gauges | t.rod | Normally Aspirated with bolt-on Forced Induction Powertrain | 18 | 10-26-2001 09:56 PM |
question about Autometer vacuum gauge | joostin420 | General Forum Archive | 2 | 12-20-2000 12:08 AM |