|
![]() |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Scooby Newbie
Member#: 387210
Join Date: Apr 2014
Chapter/Region:
NESIC
Location: Massachusetts
Vehicle:05 WRX STI Sliver |
![]() Got an 05 Sti and was looking for any company’s that can fully restore headlights? Previous owner butchered my current ones pretty bad had deep scratches. Plus he put some kind of Halo eyes in that don’t work plus the seal around the lens is horrible. I may need a completely new headlight. I know new oem headlights are an absurd amount of money so that’s out of the question.
Also would WRX headlights work with my headlight harness? I know they won’t have that tilting feature but they are far cheaper than the Sti. So if any has any recommendations or previous experience with a certain company it be greatly appreciated. Thanks
* Registered users of the site do not see these ads.
|
![]() |
![]() |
![]() |
#2 |
Scooby Specialist
Member#: 45076
Join Date: Oct 2003
Chapter/Region:
Tri-State
Location: Rockland County, NY
Vehicle:2004 Stg 2 wagon AT 16 BRZ. Both silver |
![]() Lightwerkz.net
|
![]() |
![]() |
![]() |
#3 |
Scooby Newbie
Member#: 410917
Join Date: Jan 2015
Location: Arlington, TX
Vehicle:2005 Impreza RS OBP |
![]() If you don't mind some work, you can get some wrx/rs headlight and just use the lens on them but use the rest from your current unit. At the same time you can work on the halo while you have it open.
|
![]() |
![]() |
![]() |
#4 | |
Scooby Newbie
Member#: 511213
Join Date: Jan 2020
|
![]() Quote:
|
|
![]() |
![]() |
![]() |
#5 |
Scooby Newbie
Member#: 518043
Join Date: Aug 2020
Location: Colorado,Europe
Vehicle:many STI (3)04,08,14 Blk,Grn,BlK, Red, White |
![]() Even though these are not OEM subaru, you can buy headlights new from DEPO, and have headlights that have a warranty as well as look good. They have good results for a decent price. Unfortunately, nothing is as good as subaru unless you want to spend some big $
|
![]() |
![]() |
![]() |
#6 |
Scooby Newbie
Member#: 507011
Join Date: Oct 2019
|
![]() Hope they are still in service. We'll work on my friend's new STI project after we finish installing the suspension and brake pads from 4Wheelonline onto the Wrangler and clear the garage.
|
![]() |
![]() |
![]() |
#7 |
Scooby Specialist
Member#: 180155
Join Date: May 2008
Chapter/Region:
NWIC
Location: washington
Vehicle:05 Jdm Sti 2.0 PSM |
![]() Suggest if like diy do some retrofits. Not bad to do just takes time and fine tuning at a fraction of the cost. Money towards other mods.
|
![]() |
![]() |
![]() |
#8 |
Scooby Newbie
Member#: 455076
Join Date: Sep 2016
|
![]() Check out circuit demon.
|
![]() |
![]() |
![]() |
#9 |
Scooby Guru
Member#: 487
Join Date: Nov 1999
Chapter/Region:
TXIC
Location: Greatwood/Sgrlnd
Vehicle:1998 /2005 STunIcorn Acadia Green RS-T |
![]() |
![]() |
![]() |
![]() |
#10 |
Scooby Guru
Member#: 487
Join Date: Nov 1999
Chapter/Region:
TXIC
Location: Greatwood/Sgrlnd
Vehicle:1998 /2005 STunIcorn Acadia Green RS-T |
![]() ^^best i have seen(especially for GC8s)
so many options its crazy(blue tooth to change LED colors???) expensive. |
![]() |
![]() |
![]() |
#11 |
Scooby Specialist
Member#: 180155
Join Date: May 2008
Chapter/Region:
NWIC
Location: washington
Vehicle:05 Jdm Sti 2.0 PSM |
![]() ![]() My diy I did. Don’t get me wrong to do them is some work and the headlight alignment takes some practice and still learning lol. I know dependent on how many options you add can cost over $1xxx |
![]() |
![]() |
![]() |
#12 |
Scooby Specialist
Member#: 50902
Join Date: Dec 2003
Chapter/Region:
RMIC
Location: The Mountains
Vehicle:98 GM6 60mm WB |
![]() You're almost there. Cut out fugly black trim above IC, cut out i badge and fill voids with fiberglass or other then paint match grill insert, paint match scoop delete, done.
|
![]() |
![]() |
![]() |
#13 |
Scooby Specialist
Member#: 50902
Join Date: Dec 2003
Chapter/Region:
RMIC
Location: The Mountains
Vehicle:98 GM6 60mm WB |
![]() You're almost there. Cut out or color match fugly black trim above IC, cut out i badge and fill voids with fiberglass or other, then paint match grill insert, paint match scoop delete, done.
|
![]() |
![]() |
![]() |
#14 |
Scooby Newbie
Member#: 525652
Join Date: Jul 2021
Chapter/Region:
SWIC
Location: Tucson, AZ
Vehicle:2006 STI WR Blue |
![]() Anyone know if it's possible to buy just replacement lenses? My OEM headlights are factory blackouts and I'd like to keep them but the lenses are pretty shot.
|
![]() |
![]() |
![]() |
#15 |
Scooby Specialist
Member#: 458809
Join Date: Nov 2016
Chapter/Region:
NESIC
Location: Boston
Vehicle:05 blob, 02 bug |
![]() |
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|