Tool for Welding EWG stubs into the Up-Pipe

KillerBMotorsport · 05-24-2017, 11:10 AM

We made some extras of these.

It's a 6061 EWG inlet flange adapter for a Tial MV-S (38mm). Can probably be used with a CompGate 40 too. Finned for cooling to control heat and keep the flange flat, with a 1/8NPT purge port.

Shoot me a PM if you're interested.

* Registered users of the site do not see these ads.

rexworx · 10-03-2017, 01:34 PM

How did I never see this? Did you ever make them for a 44mmTial/45mmTurboSmart Vband?

KillerBMotorsport · 10-03-2017, 02:56 PM

Quote:

Originally Posted by rexworx

How did I never see this? Did you ever make them for a 44mmTial/45mmTurboSmart Vband?

Only for the MV-S 38mm.

You shouldn't need to run a 44mm on these cars, unless you're running low boost or have a very poor EWG stud setup.

The 38mm will give you better boost modulation and even reduce high flow turbulence some

KillerBMotorsport · 11-03-2017, 05:06 PM

These are on our website and ready to ship!

http://www.killerbmotorsport.net/fabricating.html

KillerBMotorsport · 11-10-2020, 03:45 PM

Bumping this from the dead. We have one left. They work awesome for keeping the EWG flanges nice a F-L-A-T

05-24-2017, 11:10 AM	#1
KillerBMotorsport NASIOC Vendor Member#: 198281 Join Date: Dec 2008 Chapter/Region: MAIC Location: Virginia Vehicle: 2005 WRX/STi WRB of course	Tool for Welding EWG stubs into the Up-Pipe We made some extras of these. It's a 6061 EWG inlet flange adapter for a Tial MV-S (38mm). Can probably be used with a CompGate 40 too. Finned for cooling to control heat and keep the flange flat, with a 1/8NPT purge port. Shoot me a PM if you're interested. * Registered users of the site do not see these ads.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

10-03-2017, 01:34 PM	#2
rexworx Scooby Guru Member#: 103232 Join Date: Dec 2005 Chapter/Region: Tri-State Location: GTX3576R 05GD, GTX3076R'd FXT Vehicle: GTX 3071R'd 11WRX PPG,4.44,LSD,E85,6spdx3	How did I never see this? Did you ever make them for a 44mmTial/45mmTurboSmart Vband?

11-03-2017, 05:06 PM	#4
KillerBMotorsport NASIOC Vendor Member#: 198281 Join Date: Dec 2008 Chapter/Region: MAIC Location: Virginia Vehicle: 2005 WRX/STi WRB of course	These are on our website and ready to ship! http://www.killerbmotorsport.net/fabricating.html

11-10-2020, 03:45 PM	#5
KillerBMotorsport NASIOC Vendor Member#: 198281 Join Date: Dec 2008 Chapter/Region: MAIC Location: Virginia Vehicle: 2005 WRX/STi WRB of course	Bumping this from the dead. We have one left. They work awesome for keeping the EWG flanges nice a F-L-A-T